Definitely fit new O rings IMO
Eric:)
Type: Posts; User: Eric Bananaman
Definitely fit new O rings IMO
Eric:)
Thanks for sorting out the day, thanks for looking after my stuff while I was out on the track. I know it's nothing to do with Graham, but, shame to moan, but was it really on, to wait for 45 mins...
Ensure handbrake is fully off. In the old days the car was put up on stands which helped look after the tyres, I don't know if this is still applicable with modern tyres:)
Eric
Hi Vaughan
Sorry mate I was abducted by aliens
Eric
I'll be there
Eric:)
Sounds more like a leaking servo, had this in the past, brake pedal was really hard but brakes didn't work. Good luck with sorting this
Eric:)
I had a similar problem and fitting HR 25mm spacers sorted it, plus if you do all four wheels they fill the arches better and improve overall grip:)
Eric
Hi mate I,m working on Sunday but could come up afterwards to help you push the car back into your garage. I finish at 5 O'Clock in Maidstone
Eric
Hi Oni
Nissan do a repair kit, I've just bought one about £25 IIRC
But at the price of Brakes International U may as well buy yourself a new one, and if it's leaking inside the car it is a master...
Looks like you had a good time,:thumbs:well done mate
Eric
Superb day, thanks Mark for arranging things, especially the track time. Thanks Stew for looking after my junk. Once again great day:sxoc:
Eric
Thanks for all you're hard work
Eric
If you have,(or can hire an engine lifting bar(goes between suspension turrets and has a screw to lift the engine,)) you release the engine mounts and lift the engine, saves all the work of removing...
Straight bolt on and an easy job with the correct hoses. However check the wheels will still go on, I had to fit spacers to get mine to fit, but 25mm spacers mean the wheels fit the arches much...
I'd be up for this. Do fat old gits get a start?:)
Eric
Meeting more often seems like a great idea Dal. How can the police tell if we're in a convoy, we could all say we don't know each other, and it must have been chance that we were all on the same...
Is it that time of year already, hope I'll be there to freeze my bits off
Eric
Great day out, should do it more often
Eric
Hi Andypat, willing to lend a hand and tools but where are you,
Eric
Eric wil try to be there
Eric
Hello Vaughan I've got one it's a bit tight but feel free to get in touch and borrow it. I'm in Snodland so not too :)far.
Eric
Crank angle sensor checks= remove from engine(remember to mark original position first) Switch ignition on. Check voltage between terminals a and ground and b and ground whilst rotating CAS shaft...
I'll see you all there
Eric
Danny Please explain if the asbetos is turned into PTFE how does this occur.Many old (and dangerous old buildings could be turned into something useful if only we knew how.) What is the secret?:) :) ...
Danny I understood these hamsters had a high asbestos rating, which I think is not only likely to increase bearing wear, but will also be bad for the enviroment.
Eric