The problem I'm having is no matter how many times I do that sequence it just seems to keep flashing in the same rhythm, no longer or shorter flashes or pauses, just a constant flashing so it won't...
Type: Posts; User: amcm1
The problem I'm having is no matter how many times I do that sequence it just seems to keep flashing in the same rhythm, no longer or shorter flashes or pauses, just a constant flashing so it won't...
Got an s15 imported and when it arrived the air bag light was on steady. Checked connections etc until I noticed the airbag fuse had been removed from drivers footwell so I replaced it. Once it was...
If I was to do it again I'd lift the whole lot out in one go. I must have spent a good half hour at least trying to undo the top gearbox bolts and was a nightmare trying to line up the engine with...
Are there any more hoodies left?
If I remember right from the time I done it, I think you can remove the mileage counter from your old speedo and install it into your new clocks
I was having the same problem. Knock sensor code came up and lambda sensor too. Both were replaced but knock sensor was still causing problems so it was wired straight into the ecu bypassing the...
Look up Stephen Carleton on Facebook, he makes fibreglass kits in portglenone and Richard Bradley is using on of his kits on his drift car. I got a rear bumper and skirts of him and needed very...
Bkr7e coppers should do the same job and only £3 max each. In regards to changing would depend on mileage, how the cars being drove etc. best to pull them out and inspect them
Bad earth?
If you don't get a solution from Japspeed I would cut a small bit of the intake side to bring it closer to the pipe coming from the intercooler or you could cut a bit of the other end and use a...
Was it properly bled?
Bit of an update, fitted another alternator that was working fine on another car, fitted it to mine, car had to be jump started as the battery was drained from before, car started straight away,...
I'll go and buy another multimeter tomorrow as I haven't seen mine for a year or 2 so it's probably long gone and I'll get it checked, I appreciate all the help
Okay bit of an update, can't find my multimeter so won't get my hands on one until the weekend. Took battery out of the car I use daily, put it in the s14, started up straight away, idled fine, took...
Thanks for all the help and advice. Just want to try and eleminate the simple things first before I dig any deeper, so I'll check battery, alternator and maybe a possible bad earth would cause the...
Didn't think a battery would cause this sort of problem, battery has sat for nearly a year with little to no use so it's a major possibility and easiest to change/replace. Just sounded a lot like the...
Tried cleanin the afm and the connections which made it worse, car as a rough idle, I suppose if the car wasn't idling properly and trying to die the lights would come on due to not getting enough...
Bit of history about the car, had bottom end failure, took it to who is one of the best in all of Northern ireland/Ireland at working at performance nissans, he stripped the engine and replaced all...
I was having the same problem and made a copper pipe that went from the reservoir bottle to the flexi pipe to the cylinder if I remener correctly then bled it from the bleed nipple at the bottle and...
Anybody have a picture of one of these fitted to their s14? Wanting to keep my s14a pretty standard looking but would like to change the rear bumper.
Can anybody confirm this? Car is being lifted on Tuesday and need to buy a die to clean the threads to bolt subframe back in
Can anybody confirm that these are m12x1.25?
Hi,my s14a is fitted with a stage 3 chip but I would like to go back to stage 2a, how much would this cost? Thanks
Hi, I have a stage 3 chip fitted to my s14a, how much would it cost to go back to 2a? Thanks
Always hard to get good feedback, a company could have 1000 satisfied customers but you'll only ever hear about the one that wasn't.