All fitted and running plus fmic
Type: Posts; User: detsunny
All fitted and running plus fmic
only difference is the pistons the rest is det seems to start, run and boost but not shure if it will last even if i bleed of the turbo to next to no boost
I have a det that i need to re build but wanted to use the de until i sort it
Could i run de engine with turbo on low boost? with det ecu or would i need another tune?
its all good now thanks guy's the cover wasn't on the dowels properly.
Thanks for advise people.
Nightmare getting it off, as its front wheel drive but its off. Dowels are in and all the allen bolts.
Also tried another cas before i posted and that was same.
Weird
Ok i will take off the cover to check
Thanks
Yes there is scrape marks on the back
Thanks
My crank sensor catches the cam bolt heads when i tighten the bolts? loosen them and hay presto quiet again
Anybody know why??
Thanks
Is it possible to use bearing caps from a different block or are they machined in place
i mixed up two sets.
Thanks
smokes on idle when warm a little bit but when you rev snd let off it plooms
Trying to tell if my turbo is causing the engine to smoke under boost or is the oil rings not bedded in.
when the engine is cold the engine doesn't smoke but i know the turbo has a lot of side to...
Glad i asked the quesion now as i didn't realise they needed matching to numbers on the crank
Thanks guys
Ok so i am replacing my bearings in the crank and rods for standard size as wear is very minimal
Do i need to just swop them or do i need to plastigauge it
Thanks
I have done that totally removed cleaned and replaced it made no difference. even put power to it to make the plunger move in out
Ok guys its like i am getting nowhere fast, aac plug is live all the time and lights a bulb, cold start valve opens when cold and shuts when hot but dosn't make any difference to tick over or make...
Thanks guys looks like more investagative work tomoz lol i did put 12 v to the aac with the battery charger and the valve clicks i will change it for 1 that was on the de engine i know was ok ...
i have done everything as advised by you guys and re set the throttle and idle switch and i have also done all checks as manual still the cold idle aint working could i have plumbed it wrong. i...
Manual gives checks and voltages so i will do these tomorrow thanks again
I know the aac adjusts the tick over on load but what does the thin one do?
thank you i will check tomoz
the narrower one of the two on the plenum?
feel thick now ficd???? is there another name
Cold start valve opens and closes as it should but with no difference in rpm meaning it doesn't increase revs on warm up
if the aac is not working what does this affect ?? also i have had to adjust the throttle stop to keep it running??