Search:

Yes they fit, they are the same engine layout.

Why hasn't anyone mentioned the 350z brembo's?? Pretty much the the same as the skyline gtr brembo's.
Same rotor size ect and they are bolt on and seem to be £200 cheaper than the skyline gtr...

Go for the apex bushed arms dude, fit and forget.
Rose jointed arms wear out far far quicker

Arch loom

Where the cables bolt to the body they are miles off and I'm sure they might be shorter, I had both skyline cables and z32 cables side by side

Unfortunately the skyline rear brake setup is the easiest most cost affective way, if you want a hassle free setup you must go for a complete setup from a skyline ( calipers, handbrake mech, backing...

Bare in mind if you fit it in the boot they loose a fair bit of pressure by the time screen wash hits the jets

Give Conseptua tuning a call they do the rears and will probably be able to make the fronts aswell, I just bought some the other week,
Service was spot on and they were £30 all in delivered for the...

Peugeot 308 GT-Line

I would also like to know this, I pulled a complete z32 rear break setup off a 300zx from the scrappy last week and need to know for sure the cables will work on a s15

I did spot that, I managed to pick up a full set of z32 TT brakes with handbreak mech from a local scrappy on the cheap.
I'm going to rebuild then and paint them up

I might just take you up on that buddy, I will let you know

That's probibly why, we walked miles along the sea front but couldn't find ya's
I said last year I would defiantly go again, got a 1jz s15 coming over from Japan so would be nice to make the trip...

I spent the weekend there last year and it was epic, never seen and sxoc club stand tho :(

Some of you may know I sold my s14 last year. As much as I love S body's I just fancied something different.
So I got on the hunt for a replacement.
I knew what I wanted but I knew i would be hard...

I'm not overly familiar with the Mazda engine but that looks to be your water pump pulley
That won't last much longer,
Garage will probably charge hours labour roughly £40+ vat on average
And...

I would say £180-£250 depending on colour and condition

Depending on how clean or dirty it is a good jet wash wouldn't go a miss before you rub it down

I'm in

Thinking of selling my 200 as I have seen something I fancy.
basically after some opinions on what it's worth, cracking motor and very capable and reliable and it has been built properly. under...

Dude come grab the stock bumpers of my black 14 it ain't going anywhere soon

Tracking's not 10 minutes work, it takes 10 minutes to get it on the ramp and set up,
Doing a full custom setup takes a fair bit of time if done properly, hence the £80 roughly 2 hours labour

Tac weld them, works a treat, done it to two cars now and two years on still going strong, if you ever have to remove them decent chizzle will break the tac off

Mine don't

Also check your arch loom and the hazard light switch could also cause you problems