Search:

Type: Posts; User: tricky890

Page 1 of 7 1 2 3 4

Search: Search took 0.01 seconds; generated 34 minute(s) ago.

  1. Replies
    22
    Views
    7,109

    Not this time , going nurburgring. Sent...

    Not this time , going nurburgring.


    Sent from my iPhone using Tapatalk
  2. Replies
    4
    Views
    3,238

    This is to do with the ECU , had the same issue...

    This is to do with the ECU , had the same issue after I fitted a stage 1 Hdev chip into my mates ecu , exactly what your describing , best thing to do is pull the ecu apart again and move the jumper...
  3. Replies
    3
    Views
    2,521

    Dude I will sort this for you ! Be patient lol ...

    Dude I will sort this for you ! Be patient lol


    Sent from my iPhone using Tapatalk
  4. Replies
    24
    Views
    8,775

    Supra Sent from my iPhone using Tapatalk

    Supra


    Sent from my iPhone using Tapatalk
  5. Thread: Overheating

    by tricky890
    Replies
    10
    Views
    3,235

    Overheating

    I had this issue on mine , fitted a japspeed. Rad , still had the cowling aswell, it never overheated butvthe bottom rad hose was always freezing cold, I changed out the thermostat and now it’s...
  6. Replies
    8
    Views
    4,857

    Did you pay on a credit card ? Sent from my...

    Did you pay on a credit card ?


    Sent from my iPhone using Tapatalk
  7. Replies
    8
    Views
    4,857

    Is this for the parts you bought in sept 2018 ??...

    Is this for the parts you bought in sept 2018 ??


    Sent from my iPhone using Tapatalk
  8. Replies
    4
    Views
    334

    I think it may be dude nice one Sent from my...

    I think it may be dude nice one


    Sent from my iPhone using Tapatalk
  9. Replies
    4
    Views
    334

    Can’t find a post by him mate Sent from my...

    Can’t find a post by him mate


    Sent from my iPhone using Tapatalk
  10. Replies
    4
    Views
    334

    Stewart with a green S14a

    Anyone know this guy he was a llandow today and sorted me out with some brake pads . I don’t have him as a friend so if anyone knows him can u please tell him he is a legend ! He bought his car from...
  11. Replies
    5
    Views
    347

    Loose connection either on the cable or in the...

    Loose connection either on the cable or in the switch itself,
    Remove the switch ,Try putting a continuity tester on the switch and tilt and move it about . The. You will see if the switch is ****ed...
  12. Replies
    8
    Views
    444

    110 the fan should kick in by then , also if it's...

    110 the fan should kick in by then , also if it's not cooking great your water pump could be on its way out and not circulating the water sufficiently enough


    Sent from my iPhone using Tapatalk
  13. Thread: Rough idle

    by tricky890
    Replies
    14
    Views
    786

    Rough idle

    If it ran even worse after messing around with the coils I would suggest checking
    1) wires to the coil packs
    2) check your spark plugs are ok. they can snap on the ceramic insulators.


    Sent...
  14. Replies
    4
    Views
    317

    New stat I had this prob on my sr recently after...

    New stat I had this prob on my sr recently after changing to an up rated radiator , turns out the stat had gone coincidentally .
    My rad was getting hot one side and not the other, when I floored it...
  15. Thread: Rough idle

    by tricky890
    Replies
    14
    Views
    786

    Have you checked your coil packs ?? They can...

    Have you checked your coil packs ?? They can cause issues when they get warm or if completely ****ed they don't work properly at all


    Sent from my iPhone using Tapatalk
  16. Replies
    3
    Views
    267

    Half way thru lol[emoji23] Sent from my...

    Half way thru lol[emoji23]


    Sent from my iPhone using Tapatalk
  17. Right it's still in limp mode all solders are...

    Right it's still in limp mode all solders are bang on and continuity tested all the joints on the ribbon cable all is fine .

    So any ideas anyone ??


    Sent from my iPhone using Tapatalk
  18. Ok so still had issues but then I checked the...

    Ok so still had issues but then I checked the Horsham side on the daughter board and found the ribbon cables had snapped on some of the connections, just waiting now for it to be refitted and see if...
  19. Ok cool I had a bit of a nightmare as my...

    Ok cool I had a bit of a nightmare as my soldering iron end fell apart so had to use my 100w and the end is massive


    Sent from my iPhone using Tapatalk
  20. S14a won't go over 3000rpm URGENT HELP NEEDED

    so I fitted a Horsham stage 1 chip to my mates ecu , changed the jumper over etc and it wouldn't run properly, engine check light on and strange clicking noises when starting it .

    So I changed the...
  21. Replies
    15
    Views
    1,101

    Big circlips are a must Sent from my iPhone...

    Big circlips are a must


    Sent from my iPhone using Tapatalk
  22. Replies
    15
    Views
    1,101

    It's left hand thread mate Sent from my...

    It's left hand thread mate


    Sent from my iPhone using Tapatalk
  23. Are you sure your brakes weren't hot and then...

    Are you sure your brakes weren't hot and then they cooled and released off slightly ?? Same happened to my bro at the Nurburgring. Although he managed to stop any damage , apart from a few scratches...
  24. Replies
    21
    Views
    4,611

    Hello mate welcome to the best of the best...

    Hello mate welcome to the best of the best [emoji23]


    Sent from my iPhone using Tapatalk
  25. Replies
    15
    Views
    1,101

    https://www.turborebuild.co.uk/ Sent from my...

    https://www.turborebuild.co.uk/


    Sent from my iPhone using Tapatalk
Results 1 to 25 of 169
Page 1 of 7 1 2 3 4