low speed clutch drops is what does them ive found
for drifting if you initiate in 2nd or 3rd and give it a flick and let the weight of the car help you along instead of shocking it by banging the...
Type: Posts; User: Jonnay
low speed clutch drops is what does them ive found
for drifting if you initiate in 2nd or 3rd and give it a flick and let the weight of the car help you along instead of shocking it by banging the...
How sure are you it doesnt have ANY air leaks?
unplugging the maf allows them to run ok/better when you have unmetered air entering the engine which would usually cause stalling. But people...
although i agree with the above (simply replacing shells won't be a long term fix, crank will ALWAYS require attention) you can physically get to them with the engine/box in. you do need to support...
Imports have an exhaust gas temp sensor in the cat, you don't need it though, all it does is put a hot cat light on on the dash if the cat gets too hot.
Was the caster set? Lots of places round here won't touch or check it (especially if the car is lowered as it can be a bit of a pain to do a sweep) but if that's out it will pull drastically one way...
If it's siezed stuck in (arm fully retracted) you would have too much boost, you'd be hitting fuel cut.
Like someone said above, your penny flap may have come loose from the rod and be open, that...
It's the same as a T28 (or close enough to fit with no issues) but if it was siezed closed you would be overboosting rather than suffering no boost.. if it had failed and was easy to move and had no...
Actually quite watchable!
I think non genuine.
The pole position is a non reclining seat, these are recliners by the look of them and look to be modelled around the sr3. But the harness holes are not like any reclining...
Thank you very much for the advice. I was told 10 bar was about right/maybe on the low side for a used engine so I was obviously misinformed.
Will do the checks you suggested tonight
Thanks for the advice. the lad who owns it swears blind that it was running fine until last month when the turbo went. Had that reconditioned. Put it back on and now low compression.
My...
Hi people,
My friend has been offered a chance to buy an SR20 which is down on compression. We tested it and it was 4.5 bar, 8.5 bar, 4 bar, 8.5 bar. So low on all, but especially low on 1 and...
Can this be added to a policy mid-term? Sounds like a great thing to have.
There's only one variant of an SR20DET for an S14.. easy :)
Have also done this and took me a week of disconnecting the battery every night before I figured it out! :wack:
My climate control went wrong when I first got the car and could only get cold air, there are two motors I had problems with, one is on the bulkhead engine bay side where the pipes go through,...
Caster will be set unevenly I expect (it also affects the amount of camber)
Mine's done the same on both engines its been on too, defi gauge running off a sandwich plate
I thought perhaps there was some kind of clutch on the oil pump?
Mine used to do this all the time, but touch wood the last time I put it back on it really rammed it onto the metal hanger inside the tank and it seems to have gone on a bit further and stayed there,...
Mine's solid mounted and feels great, but if it's bouncing chances are your shocks have had it, bushes usually make them wander around and you need lots of small steering inputs to keep it tracking...
You could have ours repaired and on the road for under £35k realistically. That's 10k under the book price, and a lot of money to most people. Not sure how much the previous cat D would knock off...
Insurers paid out £44,420.00 to the past owner for our one
£25k is ono, tough car to price up as a repairable really ;)
Here's one I listed earlier on this week if Jaguars are your thing..
...
Do you have any of these in stock at the moment please? :)
Cost of repair and pre-accident values are only a part of what decides what category a salvage car falls into.
Ultimately it often comes down to a bit of common sense from the assessor, and...