Search:

Type: Posts; User: Micraplay

Page 1 of 20 1 2 3 4

Search: Search took 0.23 seconds.

  1. Replacing clutch on a mk1 kia sorebto diesel? Anybody dobe it or know anything?

    Looks like I'm going to have to do the clutch in the wife's Sorento. It'll have to be a driveway job tho. Just wondering if anybody had experience or tips? Ta
  2. Replies
    13
    Views
    4,316

    It's aftermarket silicone leads. New coils....

    It's aftermarket silicone leads. New coils. Didn't change the plugs tho
  3. Qurations about oil changes for flushing and oil for bleeding lifters

    I need to bleed my lifters again after rebuilding, they're a touch noisy. I've got about 15Litres of 5w30 semi in the garage. Can I use this to bleed my lifters in? Or do I need to use the same grade...
  4. Replies
    13
    Views
    4,316

    I think it's the ssv. I can move if freely by...

    I think it's the ssv. I can move if freely by hand but it's not returning fully. The last couple of mm where it contacts a switch of some sort needs help. Looks like a strip down, clean and lube up...
  5. Replies
    13
    Views
    4,316

    Does that actually work? I've done the brake...

    Does that actually work? I've done the brake pedal pump before but never had to reset the clock or dsc etc
  6. Replies
    13
    Views
    4,316

    No, how is ecu reset done on these?

    No, how is ecu reset done on these?
  7. Replies
    13
    Views
    4,316

    Oh, and yrs got brand new coil packs, first job I...

    Oh, and yrs got brand new coil packs, first job I did
  8. Replies
    13
    Views
    4,316

    I've not done compression test, but it starts...

    I've not done compression test, but it starts fine Hart or cold. When I bought it one of the plug leads wasn't connected properly. I'll put the plugs and see what they are like
  9. Replies
    13
    Views
    4,316

    Rx8 flat in mid range lacks powrr

    Got a Rx8 daily at the moment and it seems to lack power in the mid revs. It's sometimes has a little cough at 4.5-5K, then it quite flat until 7K when it noticeably really kicks in with power

    Any...
  10. Replies
    7
    Views
    483

    OK, cheers. Long list!

    OK, cheers. Long list!
  11. Replies
    7
    Views
    483

    "Starts and idles fine. Drives good and smooth on...

    "Starts and idles fine. Drives good and smooth on low revs and boost. If you bury your foot it feels like an old carbed car over fueling. Doesn't pull, but when you ease off it pulls better, as if...
  12. Replies
    7
    Views
    483

    Help with ca18det running issues

    We recently swapped out a knocking CA18 in my friends motor.
    Ever since, the new engine won't run properly. It idles smooth and mechanically seems spot on, but won't seem to rev properly at full...
  13. It's my second set of shafts this and both been...

    It's my second set of shafts this and both been the same.
  14. Replies
    16
    Views
    580

    Paid 30quid for that one I picked up

    Paid 30quid for that one I picked up
  15. Replies
    23
    Views
    916

    I've got a red top maf somewhere if you need one

    I've got a red top maf somewhere if you need one
  16. Any thoughts on this vid?

    Any thoughts on this vid?
  17. https://youtu.be/KpLzzklaQRU You can see the...

    https://youtu.be/KpLzzklaQRU

    You can see the ends of the shafts rotating with the Diff, but the shafts themselves barely moving.
  18. Good info chaps. Thanks. I took a vid of my...

    Good info chaps.
    Thanks. I took a vid of my driveshafts but I can't upload it to post.
    When I rotate the prop, the Diff transfers the movement to the driveshafts, but it looks as tho there's a...
  19. I was undecided, and in the end came to the...

    I was undecided, and in the end came to the conclusion that shoddy quality controlled items were going to be no better than stock quality designed and engineered parts. In the end I fitted gtir 54c...
  20. Are you 100% sure?

    Are you 100% sure?
  21. Replies
    23
    Views
    916

    It's the same thing, as long as it before the...

    It's the same thing, as long as it before the butterfly so it doesn't see the vacuum in the I let when the throttle is closed.
  22. Replies
    23
    Views
    916

    Look here...

    Look here http://www.plmsdevelopments.com/sr_setup_tips.shtml

    Update how you get on
  23. Replies
    23
    Views
    916

    You shouldn't adjust the idle with the throttle...

    You shouldn't adjust the idle with the throttle stop screw. That's just to stop the butterfly ja,,img shut too tight and sticking.

    You need to adjust that properly first to where it should be. The...
  24. http://i126.photobucket.com/albums/p112/sxj6151/NI...

    http://i126.photobucket.com/albums/p112/sxj6151/NICO/IMG_7469.jpg

    Which is top that goes up against the floor
  25. Just to be sure, which way round should the...

    Just to be sure, which way round should the centre bracket be?!

    Fan is unclear because it shows a nut and bolt going through from top to bottom, mine is bolted upwards into the floor
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4