not just an engine thread but a total car rebuild thread starting with some shiny bits
not just an engine thread but a total car rebuild thread starting with some shiny bits
Looking good mate!
the intake manifold and de-jetro will be put on my standard engine first while i sort out the rebuild, got loads to do, finnish the body kit, welding the rollgage suport plates, then theres the adjustable rear camber/caster arms, where do i start
so there is no budget then
What are you going to be using the car for?
decided to have a go fitting my new plenum
as you can see the boss for the temp sensors is to close to the thermostat housing and will need to be plugged and i will fit the sensors into 'WATER TEMP SENDER PORT SLEEVE' from GAUGEPLACE
modding the fuse box to give me more room
i have cut it flat and will mount it closer to the wing on a flat plate, had to do this as it fouled the throttle
what make is that manny? can you use the origanal injectors, fuel rail, ICV etc, etc with it
Looks good but where did you get that intake manifold ?
very nice indeed. That manifold looks well made, what are your thoughts after fitting?
nice stuff dude, ill be watching this thread with interest - good luck
Its gone!
That manifold looks like it takes top feed injectors rather than side feed.
well had to mod the fuel rail but it fits and made a suport that also holds my avcr, d-jetro and water injection sensors