-
Guest
Thanks for sorting my car out. Its completely transformed!!!
So much more low down power and pulls like a train. Fuel economy is fantastic compared to before.
Just want to test it out on the track now!
thanks again!!!
-
Guest
What happens if the chip is fitted before the other mods?
-
Flamethrower
Depends which mods - what were you planning on doing?
-
Guest
Stage 1a chip with all the needed parts. I have them all hear but no time to fit at the moment. Was going to be passing by a few times before/after Christmas and thought I could use the opportunity to purchase and have the chip installed. Failing that, post the ecu. But I only have the fuel pump, air filter and free flow exhaust fitted. I know I won't have a chance to fit the Fmic or a ebc/mbc anytime before march.
-
Member
I'm replying late to this thread. But went on the first long run with the Stage 1a chip fitted and over 300miles I got 33mpg! never seen that figure before! And the low end torque is unreal.
Just a question Jez, I am running an AVCR. Should I set it to run 1.2 bar and then drop to 1bar at 6500 rpm? What would you recommend?
I see on the original setup graph that the boost starts trailing off to 1bar from about 4500rpm. Should I set the AVCR to drop to 1bar then?
Thanks and great chip! :-)
-
Guest
Just a running report really. Two and a half years on, my car is still running the 1a map and hasn't been a spot of bother.
Engine hasn't been touched for anything except servicing and still pulls strongly.
-
Member
My update on the Stage 1a chip. I just had the AVCR setup properly on the rollers with a new actuator and she is making 310.6 bhp and 303 ft-lbs of torque! Fueling, etc. is totally safe.
I was hoping for 270/280 horses so am totally surprised to break the 300bhp barrier! Great chip!
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules