Wheel fitment, need help ASAP!!!

[ollieryan2005]

I am ordering some work xd9 alloys, I still need to do the 5 stud conversation
I need to no if 17inch 9.5j wide et 28 will not rub or stick miles out of the arch, I want them to look sensible no poke
This is for the rears anyway

[Pablo13]

Should be fine for the rear if you don't do to crazy with tyre size (I'm assuming this is a totally standard car, no arch work has been done), but the same wheel on the front would rub on the coilover on the inside of the wheel, would need a lower et or a less wide wheel.

[ollieryan2005]

Car has coilies and no arch with work
The fronts I'm looking to get 17 inch 7.5j wide et 38 but I don't want to run any spacers

[Pablo13]

That size on the front should be no problem

[subzero]

Fronts be a bit lost no?

[Paulpen]

http://www.rimtuck.com/

Helped me alot when deciding

[ollieryan2005]

What size would good for front then? Rears are on ordwr

[subzero]

Not sure on the setup of your car but on my s15 i have 9.5j +15 rolled arches on coilovers, no rubbing or catching, looks epic. So maybe a 9j plus 20 odd would be sweet.

[ollieryan2005]

I have 9.5 et28 on order for the rears the was going to order 7.5j et 32 for the front

[subzero]

What car they going on, 7.5 will be lost on any sbody and resale they wouldnt be saught after in them sizes imo.

[ollieryan2005]

They ate for my kouki s13
I'm just worried about the wheel hitting shocks