skyline gtst rear calipers

[ollieryan2005]

i have been offered some skyline gtst rear caliper fully rwebuilt for free
what exactly do i need to fit to my 96 kouki 180sx?

any help woulod be massively appreciated

[SstennizZ]

R33? Then just redrill the discs and get the right hoses from one of the vendors..

[ollieryan2005]

im currently doing a 5 stud conversion
what about the handbrake cables? and yeah they are r33 gtst

[Dan@DB-Power]

Your 180SX may not have a drum handbrake, if it does have a drum style handbrake then as above.

If it does then you need to rob the bits off a UK S13 to make them fit

[ollieryan2005]

well i justy broke a s14 so have loads of bits left over from that so what qould i need off that to fit them nad where can i get the correct brake lines from?

[Dan@DB-Power]

Take a picture of your current rear brakes and post it up. No point in working out what you need until we know what set-up your car currently has.

Either way S14 parts won't help you

[ollieryan2005]

okay well im about to start doing the rear 5 stud conversion so will take pics of everything as i go along and post them up in abit

[Dan@DB-Power]

[ollieryan2005]

i dont have a drum setup i no that much

[dammit]

You'll have an S14 style setup with 4 not 5 stud if it's an N/A Kouki

[magicflying198]

Replace the calipers and discs with r33 ones... use your s14 hubs so no drilling of the discs needed as will be 5 bolt...

if its a road car then you will need the r33 handbrake assemblies and cables which fit behind the hubs on the knuckles... they are a pig to fit and a press would be a big help.

I have just done the exact same on my PS13...

[ollieryan2005]

So it's full hub off jobbie and a total bitch to do then?