Driveshaft upgrade

[mattyb123]

Hey all im sick of having loads of slop in my cvs so i want to upgrade to thicker driveshafts and upgraded cvs.

I believe i can use r33gtr driveshafts with r32 gtr output shafts

I currently have a tomei 2 way in an s15 spec r pumpkin.

It has 3x2 bolt flanges

Anyone have any idea what i need.

Iv been looking for info on here and on dw but there is so many different threads that im more confused now than i was before.

Thanks for reading.

[mattyb123]

Also to complicate things further id like to change to a 4.1 ratio diff too.

[sammos13]

you can run R33 GTR shafts and R33 GTR output shafts...

i'm running them with an R33 GTR diff inside my S15 casing

[mattyb123]

As i understand to do that you need to use the r33 diff i want to use my diff in a 4.1 ratio casing but with r33 shafts.

Did you have to change your hubs too.

[sammos13]

As i understand to do that you need to use the r33 diff i want to use my diff in a 4.1 ratio casing but with r33 shafts.

Did you have to change your hubs too.

i did a comparison of the half shafts when i took them out and i dont remember them being too different. Although my memoory might be failing me on that ! i will see if took some meaasurements at the time....

yea you need change the to R33 GTR hubs also as the splined end in quite a bit thicker than standard ones.

[mattyb123]

Thanks or the help dude,

So i take it the r33 gtr hubs just bolt straight on to s body uprights.

Were the driveshafts ok for length too dude

Thanks again

[immy21]

The R33 GTR hubs bolt straight up, if you have a drum style handbrake with a properly fitted anchor bolt you will need to cut the tabs off.

Edit: When you buy R33 GTR drive shafts make sure they are supplied with the hub nuts.

[mattyb123]

I will do thanks immy. Iv put up a wanted thread on here n dw.

Thanks guys