Had an auto to manual conversion done just before I got my s13, what's ment to be screwed on here as I can see the road though the gaps.
Sent from my D6503 using Tapatalk
Had an auto to manual conversion done just before I got my s13, what's ment to be screwed on here as I can see the road though the gaps.
Sent from my D6503 using Tapatalk
Meant to be a rubber gaiter/surround.
1998 Nissan 200sx s14a , 2000 std 5 speed with nismo supercoppermix clutch bn6 Sapphire Blue
A rubber gear gaitor with a circular metal bracket with 4 screws
And a smaller rubber boot that stops crap getting in where the gear stick enters the top of the box.
Sent from my LG-H815 using Tapatalk
I have these bits but not the metal part
Sent from my GT-I9300 using Tapatalk
How much for those bits, would I be OK without the metal part
Sent from my D6503 using Tapatalk
there in my for sale thread . you could use silicone glue to seal the underneath of the rubber so no rain water splashes up and large washers with bolts through the holes until you find the metal part
http://www.sxoc.com/vbb/showthread.php?t=585162
Sent from my GT-I9300 using Tapatalk
Last edited by mospin; 16-01-2016 at 21:21.
http://www.ebay.co.uk/ulk/itm/331647468178
rubber boot for shifter assy
Sent from my iPhone using Tapatalk
That one on eBay, is it just the rubber part
Sent from my D6503 using Tapatalk
the one desa has pointed out goes over the shifter and slots on the neck off the shifter itself to stop dirt getting into the top part of the gearbox
Sent from my GT-I9300 using Tapatalk
So I need that bit as well as the other parts including the ones you have plus a metal part?
Sent from my D6503 using Tapatalk
Its the boot that fits on the spigot neck of the blue anodized plate that stick fits in. Has a small diameter that fits on stick below the weight. This seals the box at the stick pivot - stops oil being thrown out and dirt getting in the box.
The other gaiter seals the body tunnel to the stick. That stops the almighty draft.