-
Guest
How to swap bellhousing?
Trying to put an rb bellhousing on my rb20 powered s13 but I'm lost.
Is there a guide?
How do I get the bellhousing off? It seems a lot more complicated than I expected.
-
Guest
Bellhousing is the whole front case that contains 1st-4th.
Start at page MT-10.
It does appear to be missing some bits.
1: Remove the front seal carrier with the clutch pivot. Fit a new seal.
2: Remove the bolts from the centre plate. I think there are 10.
I'm not sure if you can take a short cut and not remove the rear case but just front snap ring and then "tap" (aka whack?) the front case off.
-
Guest
when you have taken the 'front seal carrier' off you have to remove the massive circlip off the big bearing.
actually,, I think there are some guide on youtube.
-
Guest
Thanks guys. The circlip was what I had missed. Got it off now. Cheers.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules