Just trying to wire up my boost solenoid and want to confirm that this is the correct place to wire it to on the Standard loom?....
Sent from my iPhone using Tapatalk Pro
Just trying to wire up my boost solenoid and want to confirm that this is the correct place to wire it to on the Standard loom?....
Sent from my iPhone using Tapatalk Pro
Yep that's the one
Tank you mate, just looking how do you determine which wore from the mac is ground? They're the same colour?
Sent from my iPhone using Tapatalk Pro
Thank you mate, just looking how do you determine which wore from the mac is ground? They're the same colour?
Sent from my iPhone using Tapatalk Pro
You going back to stock?
Sent from my SM-G920F using Tapatalk
No mate
Sent from my iPhone using Tapatalk Pro
Are you controlling it through the standard ecu?
No it's through a Link G4 that uses the standard wiring harness
Sent from my iPhone using Tapatalk Pro
That's cause the polarity doesn't matter, just crimp it in there (no soldering plz), doesn't matter which end, just take a pickOriginally Posted by dan_evans
Last edited by speedingmofa; 26-07-2017 at 14:57.
Done it like this..... I like a nice connection lol
Sent from my iPhone using Tapatalk Pro
Nice waterproof connectors
It's good to go on a bottom mount, but if you have a top mount, you'll need something to protect it from the heat too
Iv put it round the top strut on mine on the far left of the picture... might look at getting the exhaust wrapped if temps are too much...Nice waterproof connectors
It's good to go on a bottom mount, but if you have a top mount, you'll need something to protect it from the heat too
Sent from my iPhone using Tapatalk Pro
That's a very tidy bay!Very nice!! Yea, the position where it's at, it'll be just fine
Learn something new everyday
Sent from my SM-G920F using Tapatalk
That's a very tidy bay!
Thank you mate ;-)
Sent from my iPhone using Tapatalk Pro
Posting Permissions
Reply With Quote
