-
Guest
Engine nearly ready to come out, is it just these 2 14mm nuts that are holding the engine in place?? + gear box mount.
Just need to find the best bolts to hook the engine leveler onto.... sadly none at the front look good only ones at the side :-/
Going to google some pictures to see the best location to pull from. Or buy some slings.
-
Guest
i never bother with an engine leveller,
just use a bit of old seat belt and have the hook of your crane as close the the top of the engine as possible, you want the cranes jib fully extended.
put the 'lifting strap' around the rearmost inlet manifold brace that's between the upper plenum and the cylinder head near the rocker cover.
then put the top long bolt back into the power steering pump bracket and strap round that. then undo your engine mounts from underneath. engine should go in and out LIKE A BOSS. you want it to be at a proper vertical angle. a jack under the back of the gearbox can also help if your cars not at the right height.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules