T28R, Exhaust, Tein Coilovers, S13 rear subframe, head, gearbox, ECU & other bits

[krslim]

All parts can be collected from East London (near plaistow/canning town). Will post smaller stuff + Paypal fees/P&P. Whatever doesn't sell on here will end up on Ebay.
My poor old car was wiped out driving home on new years eve by some p*$$£d up f@£k (who managed to drive off ), stripping out what I can rather than going through insurance so please ask if you need anything. I still have more stuff to list that has accumulated over the years & will be trying to shift the chassis/motor/gearbox cheap (side & front end damage) for breaking/spares soon.

T28R turbo with flange. Bought on here a few years back with very low mileage (came with a few months old invoice, brand new from Apex I believe), it's done around 15k-20k on my car but been on there for a few years. Just noticed there's a slight bend on one of the compressor fin's tip, not exactly sure when this happened but think I might have bought it like this. Has always run great with no issues, sounds good & no smoke etc. There's very little play on the shaft (pretty much zero). It did have an ID tag when I bought it but it's not there any more. £280
S13/CA18 turbo back exhaust. IIRC it's a mongoose? 2.5" pipe, 5" slash cut exit. Was bought new on ebay (it's not the cheapo "ebay exhaust"), been trying to track it down in my history but it doesn't go that far back. Car wasn't very low so it didn't get abused but did catch a scrape on the downpipe when the car was being recovered recently £120
Tein superstreet coilovers (no topmounts, still on car, will get pics asap) £280
Braided turbo oil/coolant lines £30
S13 stock turbo downpipe (no o2 sensor) £20
S13 stock exhaust manifold £20
Ebay front topmounts (camber adjustable, rose jointed) £25
S13 rear subframe. Spent ages with a wire wheel removing surface rust, painted with hammerite rattle cans but never installed £50
Apex hardened rubber rear subframe bushes. Bought for S13 but think they fit S14 too, still in box. £60
S13 manual ECU (lambda), socket with H-dev stage 2 chip. £60
S13 Auto ECU (non lambda), socket with no chip £25
CA18DET gearbox. 3rd gear syncro was a bit iffy, been in storage for a while. £50
CA18DET head in bits, comes with cams, lifters, all bolts & fittings etc. This was the original head on my motor, done roughly 110k & sitting in the shed in an oily box. Car idled rough, not looked into it properly as I used another head but think the valves may just need cleaning up & were not sealing. £80
S13 AFM with adapter plate £20
S14 diff/VLSD £40
S14 brake master cylinder £20
Walbro fuel pump (IIRC 255L) £40

I have some other stuff to dig out: S14 front brake calipers, dodgy cheap set of 17" 4 stud wheels, s13 rear suspension arms, energy suspension rear arm polybosh set (new), random amount of driftworks rear polybushes (new).

Tried to price this stuff to sell but open to offers if I am off the mark, more pics coming soon. If you are after something, let me know & I will get to it asap.


T28R



Turbo back exhaust





S13 manual lambda ECU with socket & H-dev stage 2 chip.




S13 auto non lambda socketed ECU



Apex rear subframe bushes

[Adzsy]

Long shot but did the T28r sell?