Results 1 to 6 of 6

Thread: Nissan s14 differential question

  1. #1
    Guest
    Join Date
    Oct 2016
    Location
    Sweden
    Posts
    2
    Rides
    0

    Arrow Nissan s14 differential question

    Hey!

    Anybody know if a finaldrive and pinion from a s13/14 without Abs will fit a diffhouse with abs?

    Want to change from 3.692 to 4.08 in a s14 VLSd abs house

    Thanks for any help!

  2. #2
    Guest
    Join Date
    Mar 2011
    Location
    Longfield, Kent
    Posts
    1,419
    Rides
    0
    It should fit as the diff to prop flange length and case length is what changes over the two. I'm pretty sure that you will have to remove the ABS sensor to get the pinion out though. This is difficult as they usually break but it can be done with a lot of penetrating fluid, small amount of heat and a lot of patience. If it does break, a genuine sensor is very expensive but there are alternatives that are discussed in a thread on this forum somewhere.
    The crown wheel should fit without an issue.
    I had a transmission shop do that with 4.11 skyline diff insides into a S14 ABS casing, both R200 diffs. Make sure that you change all the bearings and seals at the same time for piece of mind.
    Last edited by Mike41288; 14-01-2018 at 19:22.

  3. #3
    Guest
    Join Date
    Oct 2016
    Location
    Sweden
    Posts
    2
    Rides
    0
    Thanks for the info! Top notch! ��������

  4. #4
    Guest
    Join Date
    Oct 2014
    Location
    Leicester
    Posts
    1,491
    Rides
    0
    You don’t need to remove the abs sensor to drop the pinion out luckily

  5. #5
    Guest
    Join Date
    Mar 2011
    Location
    Longfield, Kent
    Posts
    1,419
    Rides
    0
    I might be getting mixed up with the pinion bearing then

    Sent from my SM-G950F using Tapatalk

  6. #6
    Guest
    Join Date
    Oct 2014
    Location
    Leicester
    Posts
    1,491
    Rides
    0
    Yeah might need to remove it to do that but I removed the pinion to get access to the inside of the abs sensor to hammer a dead one out

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •