Hi all.
Swapped the engine over in my s14a this week. Since swapping it over it won't start.....
I have tried a few things so far.
I checked the fuel was getting from the pump (pulled off line by filter) lots of fuel...
Checked for a spark..... spark was visible
Checked to see if plugs were getting fuel... dry so no fuel to plugs.
Can anyone advise me of any steps to take to get it to start.
If you spray easy start in the inlet it almost fires up.
Ecu is a stage 3a Horsham developments so doubt nats is on car anymore (different ecu from original shell)
Thanks all.