my car rebuild thread
- Thread starter ex-ctr
- Start date
so there is no budget then
What are you going to be using the car for?
fun:nod:
i want to go around europe with the girlfriend and visit a few tracks
1 head set and 1 mains set:thumbs:
decided to have a go fitting my new plenum
as you can see the boss for the temp sensors is to close to the thermostat housing and will need to be plugged and i will fit the sensors into 'WATER TEMP SENDER PORT SLEEVE' from GAUGEPLACE
modding the fuse box to give me more room
i have cut it flat and will mount it closer to the wing on a flat plate, had to do this as it fouled the throttle
as you can see the boss for the temp sensors is to close to the thermostat housing and will need to be plugged and i will fit the sensors into 'WATER TEMP SENDER PORT SLEEVE' from GAUGEPLACE
modding the fuse box to give me more room
i have cut it flat and will mount it closer to the wing on a flat plate, had to do this as it fouled the throttle
what make is that manny? can you use the origanal injectors, fuel rail, ICV etc, etc with it
the ivc needs a simple mod, the fuel rail needs cutting so the fuel feeds from the left hand side:nod:
if your good with your hands YOU CAN DO IT
its not all done yet, i need to make a new cold pipe, and a few other things, it does seem well made the only big problem is the temp sensors fowling the thermostat housing
trying to find some where to get some boost nipples so i can connect my sensors to the plenum
Polo2
New member
i was going to say the same
takes the standard fuel rail :nod: found you just need to bend the metal feed pipe a little as it hits the manifold
